DIY Fall Burgundy Magnolia Grapevine Wreath

DIY Fall Burgundy Magnolia Grapevine Wreath

This week we are creating a stunning Fall Burgundy Magnolia Grapevine Wreath that can be used throughout the Fall season. Welcome your friends and family with this beautiful wreath that our floral designer Tim made especially for our Blog this week. You can create one of your very own using the supplies and steps listed below. As always, you can change any of the florals or accents used in this wreath to fit your decor or personal preference. 

Supplies needed:

• (1) 18" Oval Grapevine Wreath
• (2) Burgundy Magnolia Stems
• (2) 12" Fall Berry Glitter Pick
• (1) 28" Pumpkin & Pinecone Maple Berry Floral Pick
• (4) 20" Cedar Floral Spray
• (1) Cream Fall Feather Reed Grass Spray
• Wire Cutters
• Hot Glue

• Gather all of the needed supplies; remember, you can change out any of the florals or accents so that they match your decor or personal preference. 

• First we will cut the majority of the stem off of our first Burgundy Magnolia Stem. You will want to cut the stem just below where the last branch meets the main stem. Once the stem is cut we will insert it into the center of the bottom of the Wreath. You will want to add Hot Glue to the end of each stem before placing it in the wreath.

• Next we are going to cut apart our Pumpkin & Pinecone spray into three separate stems. We are going to place one stem on either side of our Burgundy Magnolia at the bottom of the wreath. We opted to remove the Pinecone & Pumpkin from this wreath. You are welcome to leave them or save them for another project like we did. 

• Now we will add our Glitter Maple Berry Picks to the wreath. We trimmed a little length off of the Pick and then placed them underneath the Burgundy Magnolia at the bottom of the Wreath. This creates a great base for the wreath. 

• To add more fulness to the center of the Wreath we are going to add the second stem of Burgundy Magnolias. You will need to cut the stem the same length as the first and insert it also into the center of the bottom of the wreath.

• Now we will begin adding our Cedar Greenery. We cut these stems into two sections and then started filling in around the wreath. 

• Lastly we are going to add the Cream Feather Reed Spray. We are cutting sections off of the main stem and placing them throughout the wreath.

• You can continue to add as much of the Cream Feather Reed Spray as you would like and you can also add any remaining greenery or accents that you have leftover. When you are finished you will have a stunning Fall Wreath that you can use all season long.

← Previous Post Next Post →